Tunnel book for Autumn

As a "thank you" to my friend Autumn, I decided to make her a tunnel book based on the story book illustrations of "The dreadful tale of Pauline and the Matches" from the Struwwelpeter.

This was my first attempt at a tunnel book, so some mistakes were made, but overall I like the results. I first sketched the planes on to dollar store watercolour paper. Then I traced over the pencil lines with a fine point sharpie (permanent marker) pen. After removing all leftover visible pencil lines with an erasure, I coloured the planes with acrylic thinned out with water. the result was about 7cmx 9cm and is about 5cm deep.

The final step was placing it in a shadow box I found in a thrift store.

Comments

DIY Fly Swatter

This is my second fly swatter I have created - they really do work! These are based loosely on the cute fly shaped fly swatters from Ameico Inc . Before I get in to my process, please note that this requires a sharp xacto blade. Please only attempt if you are an adult, and please be careful! Supplies: leather leather lacing 4 small buttons wooden dowel contact cement or similar glue for leather mod podge upholstery thread (or heavy duty thread) patten for front and back of swatter - one side is the body and wings, the other side is just the body (wings will be only one layer thick) Tools: paint brush needle leather punch with different sized holes scissors xacto blade clips to hold your pattern in place q-tip for spreading contact cement lighter to singe the ends of the upholstery thread 1) using a pattern, cut out your leather pieces, use the leather punch to punch out sewing holes around the body, as well as holes on the wings. 2) using the xacto knife, shave off ex...

DIY Bumble Bee Finger Puppet

Let me show you how I make a simple, but realistic looking bumble bee finger puppet! Supplies: black embroidery thread/ floss felt in yellow, white and black net or mesh like fabric for wings (something semi transparent) mod podge or similar paint brush for the mod podge wax paper or a surface the mod podge won't stick to glue gun scissors 1) cut out the shapes. 2) cut a piece of the embroidery floss around 25cm in length and make knots every 3 cm 3) stretch it taut on to the wax paper apply mod podge to the floss 4) when the mod podge is dry, cut the floss just 3mm past each knot 5) take the main body and apply mod podge to the leg areas and the head area. Place floss legs and antenna as desired. place the little triangle felt pieces over the legs and the oval felt piece over the head area 6) once the felt pieces and floss are sandwiched together, fold over the wax paper and place under a weighted book. Allow to dry 7) if you could not tell, the piece of ...

DIY Mushroom Candles

I love the mushroom candles on the market, but I find them expensive. I had some straight pillar candles from the dollar store which I carved into small, birthday sized candles. I carved 2-3 small mushroom candles from each regular candle. Each candle took around 15 minuets to carve. Before I get into how I carved them, I have 2 notes of caution: this will get messy, have some newspaper handy to work on top of SAFETY FIRST: this is an adult craft, use caution with blades Supplies: straight taper candle wax in desired colours (old birthday candles, natural beeswax) acrylic paint (optional) Tools: a VERY DULL BLADE (I used an old army knife a bought from the dollar store years ago) heat proof container (I used an old votive candle holder) pot of hot water to melt wax in popsicle sticks 1) with your blade, mark out a line (going all the way around the candle) the total approximate size you want your mushroom candle to be 2) snap the candle so it breaks along the line you made, slice...

betty cricket

Search This Blog